10900

この MPPT ソーラー コントローラーは、12V の鉛酸とリチウム電池で動作し、最大 10A の電流で動作し、IR リモート コントロールと RS485 リモート コントロールをサポートします。

優れた機能:

  • MPPTテクノロジー、Gel、AGM、Liなどのバッテリータイプと互換性あり
  • 最大 98% のピーク PV 変換効率
  • 全負荷動作温度 -31°F ~ 131°F
  • 自動 12v/24v 検出、Gel、AGM、NMC リチウムイオン、LFP リチウム電池タイプの充電プロファイル内蔵
  • 期間負荷制御 (タイマー + ディマー)
  • 最大出力効率 96%
  • より良い冷却のためのアルミニウムハウジング
  • 短絡、過電力保護を内蔵
  • コンパクトなデザイン、IP67 等級の耐水性

SKU: ソーラーコントローラーMP10A

SKU: Solar-ControllerMP10A

Product Description

MP10A MPPT solar controller, using the maximum power point tracking technology, real-time tracking of the best working point of solar panel, with maximum power from PV to charge the battery, PV charge efficiency can be significantly improved. Because the product can be used for charging current, the voltage can be accurately controlled. Therefore, it is very suitable for the lithium battery charging, especially for small off-grid solar power system.
Multiple operation modes are provided including automatic mode, light-control mode, and manual mode. A test mode is also available for engineering installation.

Panel Introduction

① PV indicator (green)
③ Load indicator (yellow)
⑤ PV connection terminal
⑦ Load connection terminal
② Battery indicator (red/green)
④ IR communication connector
⑥ Battery connection terminal
⑧ Installation hole

Connection Instructions:

1.Please confirm the controller is pre-programmed with the battery setup you intend to use. Contact the seller if you have any doubts on battery compatibility.
2.Please connect in the following orders: 1. load device (security camera, LED light) 2. Battery 3. Solar panel. Please pay special attention to the device polarity. Reverse polarity can cause controller/device damage.
3.Solar controller needs a minimum battery voltage is of 9V to start the controller. For a 24V system, make sure that the battery voltage is higher than 18V. The load will be light up 10s after the battery connection to confirm correct wiring.
4.The controller is compatible with both 12V and 24V solar panel, the PV open circuit voltage should not exceed 100V. The solar panel PV-MPPT should be higher than the battery voltage.

Dimension

You may also like